|
Author
|
Topic: I cant get the DOS prompt to allow me to fix a crash when exiting to tittle.....HELP!
|
Ocasious Member Posts: 114 From:North Hollywood,CA. U.S.A. Registered: Dec 2000
|
posted 01-11-2001 11:27 PM
Since I got the new wads today my editor has started to crash when I try to exit to tittle on 2 of my levels,,,unhappy to say that the library is one of them and the other is set tomb. I realy need to say that I dont know what the !*&$$# im doing. I have read the manual in the ref section and i have been to level world. I cant seem to get the DOS prompt to read anything but c:/windows...can somebody help?IP: Logged |
hagar Member Posts: 102 From:Phoenix, Arizona, USA Registered: Dec 2000
|
posted 01-12-2001 03:23 AM
I can help you with the DOS commands. It sounds like you are trying to get into the Script folder.Open a DOS window and type this command. Cd\ Now hit enter and the prompt will change to c:\> Assuming you installed the editor to the default location the following command will take you directly into the Script folder. cd progra~1\corede~1\trle\script Now hit enter and the prompt should read c:\Program Files\Core Design\trle\Script> To see a list of the files in this folder type dir/w and hit enter. When you type these commands be sure you are using the correct slash mark. There are two, forward(/) and back(\).
IP: Logged |
Ocasious Member Posts: 114 From:North Hollywood,CA. U.S.A. Registered: Dec 2000
|
posted 01-12-2001 02:26 PM
GOT IT....i found out that my problems was that i could not see the.. that followed the cd prompt in the manual, then I printed it out and it was visible what my mistake was. Thanks for the short cuts.IP: Logged |
Reb@Eidos Administrator Posts: 290 From: Registered: Nov 2000
|
posted 01-12-2001 05:50 PM
Occasious, if you are still getting the crash, make sure you read up on setting the load camera coordinates....if the coordinates in the script exist outside the 'map' area of your project, it will cause a crash to the desktop. Hope you got it working!IP: Logged |